Vetus rubbing strake insert for Quicksilver boats

Description: Vetus insert for Quicksilver rubbing strake This Vetus rubbing strake insert can be used as a direct replacement for Quicksilver part number(s): 875802BLEU and 875802GRIS. The insert is a good match for the original rubbing strake insert fitted to Quicksilver boats - please see the image which shows the Vetus insert installed into original Quicksilver outer. This is suitable for most Quicksilver boats from around 2000 to around 2014 including Pilothouse, Cabin and Commander boats, as well as Arvor boats. Colours This is available in dark blue, light grey, dark grey (near black) and burgundy. Please note that the Quicksilver burgundy insert (used on some Arvor boats, plus Quicksilver Cruiser and Cabin models) tends to fade badly over time and this generally means that the whole boat length has to be replaced at the same time. We recommend replacing the whole burgundy rubbing strip with light grey to prevent the colour fading in the future, but we do now hold a stock of the Vetus burgundy insert for those who wish to retain the original look. While a silver colour was used on some Quicksilver boats, Vetus do not make a silver rubbing strake and the Quicksilver insert is very expensive (over £14/m), so again we recommend replacing the whole rubbing strip with light grey. Please note that there can be colour variations between batches of insert. As boats may originally have used insert produced at a different time and it will have faded over time, it is likely that new insert will not match the original colour exactly. Installation The insert is quite hard at room temperature and particularly so when outside in the cold. To fit this, we recommend immersing the insert into hot water until it softens and then install it. The insert will stretch slightly when warm, so try to handle it carefully and do not stretch it when installing - otherwise it may pull tight and leave a gap when it cools. The outer can also be straightened out by heating, although we advise extreme caution if using a heat gun as the insert surface will be damaged by excessive heating - a hairdryer is more than sufficient! Ordering information - IMPORTANT The insert is sold in coils of 20m - this usually allows for replacement of a whole boat and gives some over as a spare. We are no longer able to offer part-coils, sorry. We do also have some offcut lengths available, which are one-offs. We offer a 1m length as a sample, at a reduced price to account for the carriage costs. Please note that if you order multiple 1m lengths, you will receive multiple 1m lengths, not a single length. Please note that the insert is not supplied with the outer. The insert is a sold as a replacement for damaged / faded insert, not for a new installation. We are not able to sell the outer vie eBay due to issues with carriage. Dimensions Overall width: 24mmSuitable for rubbing strake with internal width: 15-17mm Dimensions quoted are are +/- 1mm If you are unsure whether this part is suitable for your boat, please message us with the hull number or year of build and we will check.

Price: 3.6 GBP

Location: beaumaris, Isle of Anglesey

End Time: 2025-01-23T18:12:36.000Z

Shipping Cost: 23.24 GBP