Ultrasonic Solar Power Outdoor Pest Mice Repeller PIR Sensor w/ 2 Sonic Speakers

Description: This repeller is designed for permanent service allowing you to install it once and let it work! lt is weather-proof, allowing it to work all year-round and in virtually all weather conditions. It uses solar power to recharge the batteries so it's always working. The Passive InfraRed sensor(PIR)detects motion and triggers the ultrasonic speaker emitting a tone that people cannot hear but chases away common outdoor pests like dogs, cats, deer,raccoons, mice, skunks, squirrels and more.This solar animal repeller is a safe and humane way to keep unwanted animals away! WARNING! Always check for underground utilities, cables or wires before digging or installing! Failure to check could result in personal injury, property damage or even death. TO Assemble and Install: 1. Unpack the unit completely and confirm that parts are present, 2. Connect the repeller head,pole sections,connecting part and groundstake. 3. Mode 1: Turn the power switch to the "left" position. 4. PIR reflector is designed to be on continuously. It uses 1200 mA 18650 lithium battery. 5. When the switch is turned on, the red light lights up and the ultrasonic signal will work for 30 seconds. During this time, sound waves will be generated for 30 seconds. At the same time, the white light will flash strongly. After 30 seconds, this product will enter the standby state. 6. Now the product can be installed. The installation site should be able to receive enough sunlight to make the battery fully charged. Please ensure that the area to be protected is within the working range of the ejector. 7. For best results, koep the repeller head roughly9-10 inches above groud. 8. Take care not to stress or break the repeller when installing in hardground. It is a good idea to prepare the ground for the ground stake toavoid damage to the unit. 9. Mode 2: Turn the power switch to the "right" position. 10. When the infrared sensor detects the signal, the red light will light up. Ultrasonic waves are emitted, and the white light will flash for 30 seconds. After that, the ejector will return to the standby state. 11. When the device is working and the infrared sensor detects the signal again, the driver will continue to run for 30 seconds. CAUTION: • Allow the Animal Repeller to operate continuously for best results. • Do not immerse repeller in water. • Do not cover-up the PIR sensor. • To clean the repeller,use a damp-soft cloth and mild soap withWater. Do not use harsh chemicals or abrasive cleaning agentsThat may damage the repeller.

Price: 15.88 USD

Location: Palo Alto, California

End Time: 2024-09-21T08:21:50.000Z

Shipping Cost: 0 USD