Description: Specification: Module name: dual H bridge motor drive module Work mode: H bridge drive (double road) Main control chip: ST L298N dual H-bridge driver chip Logical voltage: 5V Drive voltage: 5V-35V Logical current: 0mA-36mA Driving current: 2A(MAX single bridge) Storage temperature: - 20 ℃ to + 135 ℃ Maximum power: 25W Driver Board Weight: 33g Dimensions: 43x43x27mm Notes: 1. General Application: When your driver is 7V-12V, you can enable the on-board 5V logic supply. 2. When using the on-board 5V power supply, the + 5V power supply in the interface does not input voltage, but it can draw 5V voltage for external use. 3. Unconventional application of high-voltage drive: When the driving voltage is higher than 12V, less than or equal to 24V, for example, to drive a motor with rated voltage of 18V, the jumper cap with 5V output enabled on-board voltage must be pulled out and then outside the 5V output port Connect 5V voltage to L298N internal logic voltage supply. There are two ways to turn the system back on: 1. flip the power switch on the back of the computer and wait for the power supply cap to discharge as the relay will reset without power. 2. after popping the hood and examining for faults, press the button on the relay.There is a red LED on this for power and a green LED to indicate the relay is activated, so you can be pretty sure what state this is in. Any time you are trying to hot wire an ATX power supply and you need a toggle function besides the switch in the back, just needs power from pin 9, the relay connected to pin 16 and then of course connections back to ground pin(s). Package Includes: 5 X L298N Motor Driver Controller Board Module [High Quality] Main driver chip L298N, strong driving ability, strong anti-interference, low calorific value, afterflow diode protection, more stable and reliable for Arduino projects [High Efficient] Double H bridge design, can drive one 2-phase stepper motor, one 4-phase stepper motor or two DC motors, high efficient [Easy to Use] No assembly required. This L298N board comes ready to go. Just wire up motors and power, easy to use [Parameter] External size 43*43*27mm / 1.69*1.69*1.06 inch, voltage 5V-35V, drive current 2A (Max single bridge) [Wide Usage] Great for for Arduino DIY Smart Car Robot Power UNO MEGA R3 Mega2560 Duemilanove, if driving voltage is more than 12V, use external standard 5volt TTL outputs to switch the H-bridge circuits
Price: 24.49 USD
Location: Brentwood, New York
End Time: 2024-12-24T21:20:57.000Z
Shipping Cost: 0 USD
Product Images
Item Specifics
Restocking Fee: No
Return shipping will be paid by: Seller
All returns accepted: Returns Accepted
Item must be returned within: 30 Days
Refund will be given as: Money Back
Brand: TIMESETL
Type: Does not apply
EAN: 0611702529715
Package Dimensions LxWxH: 9.49x5.98x2.2 Inches
ISBN: 0611702529715
Size: 1.69 x 1.69 x 1.06"
Color: L298N Driver
Weight: 0.3 Pounds
