TACKLIFE Stud Finder Wall Scanner, 4 in 1 Center Finding Electronic Wall Detecto

Description: Product DescriptionTACKLIFE DMS03 Stud Finder. The tool is used to detect metals (ferrous and non-ferrous metals), wood studs, and “live” AC wires in walls, ceilings and floors. To achieve the best performance of detection, please read this user’s manual carefully and thoroughly before using the tool.NOTE:The detector’s ability to detect objects is affected by the proximity of other equipment that produce strong magnetic or electromagnetic fields, and by moisture, the size of objects, metallic building materials, foil-laminated insulation materials and conductive wallpaper.Maintenance and cleaningUse a dry, soft cloth to remove dirt from the instrument. Do not use cleaners or solvents.Do not put any label or nameplate on the sensor area of the detector.Use the included protective bag to store and carry the detector.Plush mat on the backThe cotton on the back has prevented the damage caused to the wall, providing you a safe and convenient detecting environment.LCD backlight displays the detection mode, depth detection, detection signal strength, center point, auto calibration, battery indicator that is easy to see and understand.·To find the center of the wood and metal studsThree indicator light for telling you the detecting situationUnlike the other stud finder, the TACKLIFE DMS03 has additional function for detecting the center of the stud.What's more, it has three different indicator light, the function is as bellow:Green: The detector has calibrated automatically and get readYellow: Getting closer to the targetRed: The center of the sensor was locatedAutomatic switch-off: Approx.5 minutes of inactivityOperating Temperature: -10℃ to 50℃ / 14℉ to 122℉Storage Temperature: -20℃ to 70℃ / -4℉ to 158℉Operating relative humidity: 35% - 55%RHPower Source: 1*9V BatteryScanning for metal objectsMaximum detection depth: Ferrous metals: 100mm; Non-ferrous metals (Copper): 80mm.When the metal is detected, the screen will show the depth value synchronously, but if the signal is weak, or the tool cannot distinguish that the metal object is magnetic or non-magnetic, the depth value will not be displayed. The depth value is the distance from the center of the sensor to the scanned object. At the position of minimum depth value, the metal object is located near the center of the sensor.How to find the studStep 1Hold the tool straight up and down, position it onto the surface to be scanned, and do not rotate the tool.Press the mode button briefly to enter the wood stud detection mode, the symbol will flash on the screen. Do not move until the symbol stop flashing and the green light is on, automatic calibration of the tool is completed.Step 2Move the tool uniformly and slowly over the surface without lifting it off or changing the applied pressure. During the scan , the tool must cling the wall, otherwise it will automatically calibrate again. Please wait for the symbol stop flashing and the green light to light up again and then move the tool.Step 3When the tool comes close to a stud, the scale m and the percentage n will increase, the distance indicator l will appear. As the tool gets closer to the stud, the yellow indicator will light. As it detected the center of the stud, the red light is on.Step 4To make the detection results more reliable, when the center is marked, please slide the tool across the wall again to check if the center is near the location of the highest percentage.

Price: 26.98 USD

Location: Levittown, New York

End Time: 2023-09-23T03:18:00.000Z

Shipping Cost: N/A USD