Soap Dish V3 for Kohler Shower Bar Mount - Bracket Shelf

Description: Soap Dish V3 for Kohler Shower Bar Mount - Bracket Shelf - Shower Rod. Soap Dish for Kohler Shower Rod Mount. Version 3 **Updated Jan 2023** Now printed with PETG After looking everywhere and not finding a replacement for a broken Soap Dish, I decided to make my own... This is a custom 3D-Printed shelf that will replace your cracked or broken one. This version is a Smoked PETG Plastic Material which looks good with the Nickel finished shower rod. This soap dish has a flat top surface with a textured finish. It does not have the concave surface of the original (due to the way it is printed), but you can rest a bottle or soap bar on the surface, and it should stay put. To Install, simply pull down on the upper rod cap and tilt out the top of the shower rod. Then pull the rod up and out of the soap dish mount. There is a Phillips-head screw holding the dish to the lower mount. Unscrew and replace... The rubber gaskets and trim pieces (not included) only go in one way, so you will have to line them up. I've matched the way the original dish mounts, and I added some ribs for strength, so this version should last longer than the original!. Note: As these continue to sell, I print more. Therefore, I update the quantity when I have the parts finished and ready to ship. I'm slowing the print down to increase the quality... Current print time is 11 hours! Update 1-9-23: **Version 3: - The Previous Version (V2) was printed with PLA (Plant-Based) Plastic. However, while it looked good, it became brittle and cracked over time. Please contact me if you have purchased one of the older versions before ordering...

Price: 15 USD

Location: West Bend, Wisconsin

End Time: 2025-02-10T02:11:53.000Z

Shipping Cost: N/A USD