Rubber Molds for Concrete or Plaster, Limestone Trim Stone, 4 Count

Description: Limestone texture on front, 4 smooth sides; 4 STONES PER MOLDNo release agent necessary, saving you money, time, and clean up, as well as easy, clean release of face color pigments, unlike plastic moldsProduction quality molds can be used hundreds of timesMade in the USA from plastisol rubber, including recycled plastisolUse as baseboards, door trim, window trim, etc. Stone Master Mold's limestone textured trim stone mold yields four trim stone pieces, each which is approximately 21" long by 4" wide by 1" thick. Save tons money and pour your own concrete trim pieces, which are easy to install and can be used for baseboards, door trim, window trim, and even borders. Manufactured Stone Basic Mixing Procedures Using A Pre-bagged Concrete Mix: This is one suggestion for mixing the concrete for manufactured stone. There are many other instructions available online, including videos. BE SURE TO USE A CONCRETE MIX THAT CONTAINS PORTLAND CEMENT. We recommend Sakrete Maximizer, as it has lightweight aggregate, is high strength, and yields more product, but there are many kinds you can use. Follow the manufacturer’s instructions for mixing. If using pigment, add desired iron oxide pigment to mixer (100% pure, no additives). These can easily be found on Amazon, etc. A plasticizer can be added to reduce the amount of water in the mix. Pour into the molds which may already have coloring additives… NO RELEASE AGENT NECESSARY. Vibrate molds to release air bubble. Cure in the molds for approximately 24 hours at the minimum of 70 degrees Fahrenheit before demolding. Higher humidity is desired. Molds can be covered with a tarp to retain more heat and humidity. Continue to cure demolded stones at 70 degrees or greater until ready.

Price: 139.95 USD

Location: Kansas, Oklahoma

End Time: 2024-02-21T18:46:24.000Z

Shipping Cost: 0 USD