Polymer Clay Cutter set of 2 | Leaf Clay Shape Cutter

Description: ----- PLEASE READ FULL DESCRIPTION BEFORE PURCHASING ----- Polymer Clay Cutter set of 2 | Leaf Clay Shape Cutter | Unique clay cutter | DIY Craft tools | Polymer clay Earring cutter| - The cutting edge is less than 1 mm thick to get a clean cut so that the after cleanup is to a minimal. It is expected that a small amount of sanding of your polymer clay piece is required after using these cutters. We do not guarantee a perfect cut, but it will be a relatively clean cut. - The Polymer clay cutters comes in pack of 2. - If you are after a specific type of size of a cutter please send me a message and I can customize it for you. Hope you have fun getting creative. ----------------------------- RECOMMENDATIONS - A stiffer clay would be easier to work with while cutting out the clay with 3D printed cutters to get a firm cutout edge. - If you are living in a hot and humid climatic condition, then sometimes your clay can sticky. To avoid your clay getting stuck inside the cutters, place a piece of cling wrap on top of your roller out clay and then use the cutters to cut out the shapes. Or you could also work your clay with corn flour or polymer clay powder before pressing the cutters into the clay - Apply pressure firmly and evenly on to the cutters to press down the clay to cut all the way through. Don’t apply sideways pressure as this would distort the clay shape. - Usually 3D printed cutters don’t give a clean cut so once you remove the cutters from the clay, make sure to trim the edges if there is any excess before backing so that you spend less time sanding the pieces. ----------------------------- CARE INSTRUCTIONS - The material of the Cutter and Texture roller is PLA Eco Plastic so keep away from heat temperature higher than 70 °C - Wash before first time use. - Hand wash only.

Price: 24.9 AUD

Location: Blacktown, NSW

End Time: 2024-09-09T07:11:31.000Z

Shipping Cost: 6.58 AUD