Pioneer Universal Add-on License-Plate Blind-Spot Detection System

Description: Pioneer SDA-BS1 - License Plate Radar Sensors, Microwave Radar Technology, Speed Sensing - Blind Spot Detection License Plate Bar with built-in radar sensorsHigh accuracy digital microwave radar technologyInterior audible and LED indicator alertsGPS unit for speed sensingLicense Plate Bar is IPX6 and IPX7 ratedLED indicators with pre-installed black color covers1-year warranty The Pioneer Blind Spot Detection System (BSD) SDA-BS1 is designed to assist in detecting vehicles entering your vehicle’s blind spot zone*. While driving, the system detects objects entering your blind spot zone around the rear of your vehicle and in the lanes on the left and right of the vehicle with an approximate detection range of up to 50 feet. When you’re slowly backing out of a parking spot or driveway, cross traffic approaching from your left or right entering your blind spot zone will activate the buzzer and the LED indicator(s) to signal the direction of approaching vehicles and warn the driver.* This product functions as an aid for notifying the presence of obstacles in vehicle blind spots. It does not detect all dangers and obstacles and is not a substitute for your judgment and careful attention. Before any maneuver, visually check both sides of the vehicle to confirm.GPS Antenna IncludedThe SDA-BS1 comes with a GPS antenna, which is used to calculate your vehicle’s moving speed. On startup, it may take up to 2 minutes to engage; once engaged, both LED indicators will flash twice to indicate the GPS system has been activated. There are 4 speed sensing thresholds. The factory default is set to detect and warn at threshold speeds at or above 20-mph. At speeds under the 20-mph threshold, objects will not be detected.License Plate Bar InstallationInstallation requires the License Plate Bar be positioned horizontal to the road for effective detection. Mounting wedges are provided to achieve the horizontal position when needed. The SDA-BS1 License Plate Bar must be installed on the center rear of the vehicle for sensor detection to function properly. For this reason, license plates designed towards the right or left side of the vehicle are not suited for the SDA-BS1. Because license plates may vary in configuration from state to state, the SDA-BS1 can be mounted above or below the license plate.IPX6 and IPX7 RatingThe SDA-BS1 License Plate Bar with built-in microwave sensors has an IPX6 and IPX7 rating. However, the Control Unit is not waterproof and requires installation inside the vehicle.FEATURESType Control Unit with license Bar Radar SensorsWarranty 1 Year LimitedIngress Protection Rating License Plate Bar: IPX6/IPX7Speaker+GPS Antenna+GENERALMounting Location Rear License Plate Center installation requiredMain Harness 1 PieceSensor Cable 1 PieceLED Extension Cable 1 SetLicense Plate Bar with Configurable Radar Sensor 1 PieceLED Indicator 1 SetLED Indicator Lens 2 Pieces (black)Wedges 5 °, 10 °, and 15 °Attention International customers: You are responsible for any and all customs, import duties, brokerage fees, and taxes. These charges are not included in the item price or stated shipping charges.Additional shipping fees are required for locations including, but not limited to: PO Boxes, APO/FPO locations, Alaska, Hawaii, Puerto Rico, Guam, Saipan, Virgin Islands and other countries outside the USA.

Price: 399 USD

Location: Rosemead, California

End Time: 2024-02-28T00:33:53.000Z

Shipping Cost: 0 USD