Packout Mount for Milwaukee M18 & M12 6-battery Rapid Charger Station 48-59-1807

Description: Charger, batteries, and Packout tool boxes not included Stay up to date and learn more at @RNoksDesigns Finally, a way to mount the Milwaukee M18 & M12 6-battery Rapid Charger Station 48-59-1807 to a Packout Tool Box/mounting system! Product FeaturesSupplied product replaces the black base of your chargerNo permanent modifications needed to your charger (you can always put the stock base back on)All mounting hardware includedConvenient cable management slot to keep cables tidyIncludes stainless hardwareI chose to orientate the charger as pictured so you could place the charger on the right side of a Packout Lid and even with M12 batteries installed, you should have enough clearance to mount another half-width Packout product to its left without it interfering.See below installation instruction Installation Details Required toolsT20 Torx Tamper Proof Style - Included (note, I provide a 1/4" bit only, you provide a 1/4" socket screw driver)3mm Allen Wrench - Not IncludedInstallation InstructionsUnscrew the 8 T20 Torx screws from the bottom of the charger with included bit (NOTE - one of the 8 screws is behind the Milwaukee sticker (I suggest using an Exacto knife to cut out the sticker to gain access)Remove Milwaukee black baseSlide the two halves of the new base together, making both halves flush to each otherFor the side that has one dovetail, screw in the LONGER (35mm) Allen screwFor the side that has two dovetails, screw in the 2 SHORTER (30mm) Allen screws on each sideThe base comes with all 4 red Packout feet mounted, but you will need to remove two of them to gain access to the base mounting holes for the Torx screws.Tighten the 8 Torx screws to secure the new base to the chargerReinstall the two red Packout clips you just removedRoute cable in cable management slot if desiredEnjoy! Other TidbitsAll are designed and made in USA by yours truly, 3D printed.Made with PETG filament which when compared to the commonly used PLA, offers improved strength and also high heat resistance (PLA has a poor resistance to heat and can cause deformation). Silly Fine PrintDesigned for genuine Milwaukee M18 & M12 Rapid Charger Station model# 48-59-1807, will not work with other models. Charger, batteries, and Packout tool boxes not included

Price: 64.99 USD

Location: Oregon City, Oregon

End Time: 2023-09-12T21:07:33.000Z

Shipping Cost: N/A USD