icemaker ice stripper reinforced #W10699925 for 8 cube modular type ice maker

Description: NEW #W10699925 icemaker ice STRIPPER (stationary). This listing is for ONLY the STATIONARY ICE STRIPPER, unit in last picture is shown for demonstration purposes to show type of unit this fits onto. Maintains ice from re-entering mold during the harvest cycle (provided cubes are correct size >>> a full fill is 140ml (140cc) or 4 ounces of water). These strippers will be clean and have NO broken mounting (3) tabs and have not been stored where sunlight is present. LAST 4 pictures show type of unit and dis-assembly procedure for Mechanical separation of control head from mold (where ice is formed at) is required to install this part (you will need a #2 PHILLIPS screwdriver). This W10699925 has Factory Heavy Duty/Reinforced strippers compared to 2182124 / This W10699925 stripper replaces and is "beefed up" (reinforced) more so than the # 2182124 icemaker ice STRIPPER. This listing is for ONLY the STATIONARY ICE STRIPPER, unit in last picture is shown for demonstration purposes to show type of unit this fits onto. Maintains ice from re-entering mold during the harvest cycle. The "hole" in far end designates this as a "BEEFED-UP/REINFORCED" version of the original 2182124 stripper and can be its replacement too! NOTE #1: If you have ice cubes that are trying to re-enter the mold area and getting hung up in this stationary stripper (and possibly breaking it) then you may have too little water amount during the fill portion and cubes are TOO SMALL / check for some type of water delivery problem such as pressure (incoming supply should be a minimum of at least 30psi +) /also if one of the cube stripper separators is broken off then you will experience re-entry of the cube causing hang up and then ice production lock down and then NO icemaking will take place until after blockage is physically/manually removed. Will work on Sears, Maytag, Amana (IM #D7824701, 02, 03, 04, 05, 06, + 06Q) and Whirlpool (IM #4317943) + others of the module type. Normal fill quantity is 3.5 to 4 ounces per fill OR 140cc's. THIS WILL NOT FIT ON ELECTRO-MECHANICAL icemaker units. See last picture for type it will fit. IF IN DOUBT ABOUT CUBE SIZE >>> IN AN EMPTY MOLD (WHERE ICE IS FORMED AT) SLOWLY AND MANUALLY FILL THE EMPTY MOLD WITH 4 OUNCES OF WATER AND LOOK AT CUBES AFTER THIS HARVEST AND THIS WILL BE THE PERFECT SIZED CUBES THE UNIT SHOULD BE PRODUCING ON AN ONGOING BASIS. NOTE #2: Mechanical separation of the control head from the ice mold (where ice is formed at) is necessary for this part to be replaced. NOTE #3 = I also have available (not shown) the rotational (fingerbar 627843 ejector) that harvests the ice; please inquire (same price). My inventory is a mixture of new and previously owned ice strippers and ALL will be clean and very presentable and in GOOD condition and all have been stored inside with NONE discolored and NOT exposed to sunlight. NONE will have broken mount tabs!

Price: 18.5 USD

Location: San Angelo, Texas

End Time: 2024-08-19T00:17:23.000Z

Shipping Cost: 5 USD