EZON LED Lighting Series for SCX10 III JT Gladiator

Description: Introducing the new WATERPROOF “EZON” Lighting Kit for Axial SCX10 III Jeep JT Gladiator from Club 5 Racing. Designed from the ground up, specifically for Jeep JT Gladiator that includes all the basic functional lighting.This kit has included the following: 1. HeadLight ( 5mm white x 2 )2. Rear Blinker / Signal ( 5mm Dual color red / amber x 2 )3. Rear Light Buckets, 3 set of Tail Light Cover Guards4. Reverse ( 5mm White x 2 ) Please choose the EZON only If you have already purchased the rear light bucket.All other optional lightings featured in the listing photos are NOT included.This kit does NOT work with stock SPEKTRUM™ FIRMA™ SMART 40A BRUSHED 4-CHANNEL ESC/RECEIVER One of the key design feature is that we have splitted the control units into two circuits: Primary circuit on the body for all the LED connections and the Secondary control circuit with very small footprint remains on the chassis. So when you need to remove the body for replacing battery or if you need to do other maintenance, there is only ONE wire to disconnect from the chassis.The Y connections to the Servo (CH1) and ESC (CH2) is also integrated into the secondary circuit to make the whole set up tidy. And there are two more outlets each available on both primary and secondary circuits for your additional needs such as roof rack lighting, flood lights, high mount brake light, front / rear bumper lights, rock lights...etc. And the best part is that you have total control over all the lights via your transmitter without any other remote control unit. Installation can be done in 3 easy steps:1. Attach all LEDs from primary circuit to your Jeep JL body 2. Reconnect steering servo / ESC / 3rd channel servo to secondary control circuit and receiver. Please be patient and pay special attention +/ - directions and it may damage the circuit and even your ESC if you got directions wrong.The first Y connection on the secondary circuit ( With Yellow tape ) is for the steering servo. Just remove the steering servo plug ( CH1 ) from the receiver and plug it into the female end and plug the male end of this Y connection to CH1 on the receiverThe second connection on the secondary circuit ( NO yellow tape ) is for the ESC. Just remove the ESC plug ( CH2 ) from the receiver and plug into the female end and plug the male end to CH2 on the receiver.The third connection you need plug the single wire connector to CH3 on the receiver. Please make sure all connections are secured and the correction directions.3. Connect primary and secondary circuit to complete.Our Easy On control circuit will works on most 3 channel transmitter with two position third channel control such as Futaba or Speckrum. Besides turning signal lights, brake lights and reverse lights will come on as controlled from the transmitter, you can have the total command over all the lights remotely through the third channel. External BEC is recommended if other optional lights and installed. Zip ties and 3M Body wire clips includedExternal BEC is recommended if other optional lights and installed. Check out our Instagram page : Club5racing for more exciting products and reels. Get ready to embark on your next scale adventure!

Price: 74.99 USD

Location: Rosemead, California

End Time: 2024-09-06T08:56:05.000Z

Shipping Cost: 0 USD