Dual PM Gear Motor Radio Wireless Remote Control 12v DC

Description: This control set enables a user to run two motors at the same time. Function: To provide forward/reverse functions for up to two 12v dc brush type motors by receiving wireless signals of a remote control. The radio receiver has two channels for connecting up to two motors, and each channel has its own current limiter. When the motor of each channel is stalled/overloaded up to 8 amps, the receiver will stop so the user can only press the other button for the reverse direction. Control Mode: Latch mode. This means when the user presses one button once (not holding it), the motor of each channel will rotate in one direction until the user presses the button again to stop it. Just like a garage door control. Application Example: Dual-side slide doors that require two 12v dc gear motors for opening/closing. When the user presses one button for closing for example, two doors will roll to closing. When either door reaches its end and causes its motor to overload at 8 amps, the corresponding channel of the receiver will shut down that motor, same function occurs to the other door. About the Motors: Two units are included with this package. Rated Voltage: 13.5 VDC Rated Speed: 50 RPM Rated Load: 60 Watts Rated Torque: 6 N-m (4.4 ft-lb) Mounting: M6 screw holes Shaft: 10mm shaft with 2 flats where flat to flat is 6.6mm and threaded end to fit a M6 tightening nut

Price: 197 USD

Location: Corona, California

End Time: 2024-10-12T05:08:35.000Z

Shipping Cost: 18.4 USD