DROK DC Buck Module Adjustable Buck Converter Step Down Voltage Regulator 6V-...

Description: DROK DC Buck Module, Adjustable Buck Converter Step Down Voltage Regulator 6V-32V 30V 24V 12V to 1.5-32V 5V 5A LCD Power Supply Volt Reducer Transformer Module Board with USB Port Protective Case PARAMETER --- Input voltage range DC 6V-32V; Output voltage DC 1.5V-32V; Max output current 5A, recommend use of within 4.5A; Max output power 75W, recommend use of within 50W. GENERAL USE --- As ordinary step-down module with over-current protection; As constant current LED driver module; DIY a solar power controller, etc. DISPLAY --- Large clear digital LCD display voltage & current value simultaneously. FEATURES --- Constant current/voltage mode; Voltage calibration & current calibration; USB interface; Protective case; Short-circuit protection; Over-temperature protection; Input reverse connection protection. NOTE --- 1). Output voltage is set as around 20V by default, if your input is lower than that, please turn potentiometer anticlockwise for 10 laps or more until voltage changes. 2). The case is packaged unassembled to avoid damage during transit. It needs to be manually installed. 3). Please carefully read the user’s manual, especially the “Cautions” before using. You can find the PDF Instructions on this page -- Product information -- Product guides and documents -- User Manual [PDF]. Parameters： Chip: MP2304 Input voltage: 6~32V Output voltage: 1.5~32V continuously adjustable (Input should be 1.5V higher than output.) Output current: 5A max, adjustable, recommended use within 4.5A. (Over 3A or 35W, please enhance heat dissipation.) Constant current requires an output voltage of above 2V to be adjusted. Current regulation can only be performed in the status of constant current. Output Power: 75W (max), recommended use within 50W. Please reduce the power when voltage difference is large. Operating temperature: -20℃ to +70℃ Operating frequency: 180KHz Conversion efficiency: up to 96% Short circuit protection: Yes (Constant current value set by constant current function) Over-temperature protection: Yes (Automatically shut off the output when overtemp.) Input reverse polarity protection: Yes Output backflow prevention: None. Please add a diode when used for charging. Installation: 8x pillars, 8x 3mm screws Wire Connection: terminal block or soldering terminals; VIN is input; VOUT is output. Dimension: 65.6*40*25mm Display Modes: 1). F-0 mode: Display output voltage 2). F-1 mode: Display input voltage 3). F-2 mode: Display input and output voltage alternately 4). USB mode: Display USB output voltage & turn on/off USB output Note: Output is set as around 20V before leaving factory, if your input is lower than that, please turn potentiometer anticlockwise for at least 10 laps until voltage changes. Package Included: 1x DC Buck Module 4x Copper Cylinder Screws M3*6 4x Double-pass Screws M3*12 8x Roundhead Screws M3*6 Shipping We offer FREE shipping on all orders! We ship within Three business days of payment, usually sooner. We use a selection of shipping services such as UPS, FedEx, USPS etc. We only ship to the lower 48 states, no APO/FPO addresses or PO Boxes allowed. Local pickups and combined shipping options are not provided at this time. Return You can return a product for up to 30 days from the date you purchased it. Any product you return must be in the same condition you received it and in the original packaging. Please keep the receipt. Payment We accept payment by any of the following methods:PayPalPlease pay as soon as possible after winning an auction, as that will allow us to post your item to you sooner! Feedback Customer satisfaction is very important to us. If you have any problem with your order, please contact us and we will do our best to make you satisfied. Contact Us If you have any queries, please contact us via ebay. We usually respond within 24 hours on weekdays. Please visit our eBay store to check out other items for sale! Thank you for shopping at our store.

Price: 27.16 USD

Location: Los Angeles, California

End Time: 2024-11-25T18:01:13.000Z

Shipping Cost: 0 USD