DMC, Daniels MFG, M22520/1-01 Standard Adjustable Indent Crimp Tool, p/n AF8

Description: DMC, Daniels MFG, M22520/1-01 Standard Adjustable Indent Crimp Tool, p/n AF8 The DMC AF8, qualified to MIL-DTL-22520/1* and AS22520/1*, has virtually limitless application within the specified wire range of 12 through 26 AWG. Over a thousand turret heads are available to adapt the tool frame to your specific military or proprietary contact/wire combination. The 8 impression crimp, which is standard in the AF8, assures absolute maximum tensile strength with almost every closed barrel contact. Special indent configurations and gaging are available upon request. For proper operation, the tool must be mated with one of the following optional accessories: a military standard or non-military turret head (TH-XXX Part No. Series), a military standard or non-military positioner (TP-XXX Part No. Series), or an adjustable head (Part No. UH2-5). This is done simply by orienting the head in the keyed position, and by tightening the hex socket screws provided as part of the head. The precision ratchet controls cycling of the tool in both directions of handle movement. This assures the same accurate crimp every time. It's like having a quality control inspector at every work station.Positive crimp depth is controlled by an 8 position selector knob conveniently located on the tool frame. The operator simply dials the desired step for the wire being used. This setting can be secured by use of a locking pin or safety wire.A permanent dataplate is affixed to all turret heads and positioners. This plate lists specific contact part numbers, the corresponding position color code (for 3 position turret heads), and suggested selector depth settings for the wire size being used. The AF8 is approximately 9.75" x 2.5" x 1.25" and weighs 15 oz. Periodic gaging is recommended to insure accurate calibration. This can be done easily by setting the tool selector knob to position #4, and checking indenter closure with the M22520/3-1 Go/No-Go gage (DMC part no. G125). For a complete set of non-Mil-Spec Go/No Go gages for all selector settings, see DMC part no. 88-100. Other than keeping the unit clean and properly stored when not in service, no operator maintenance is required. DMC offers complete factory service by knowledgeable technicians within a reasonable turnaround time. Complete instructions concerning the use, care and warranty are supplied with each tool. 1123FREE DOMESTIC SHIPPING with tracking numberFor International Shipping* we use eBay's Global Shipping Program (Courier Service) for safe, fast and secured worldwide shipping.*International Shipping is the cost of shipping the item to your destination country. Please, be advise this cost does not include any import duties or fees your country's Customs might impose on the importation of this item. We, have no control on the import duties or fees or the amount.Thanks for landing @ World Pilot Supplies, an Authorized DealerHablamos Español

Price: 539.99 USD

Location: Hialeah, Florida

End Time: 2024-09-02T14:24:41.000Z

Shipping Cost: 0 USD