DesignerLash Eyelashes DIY Extensions

Description: DIRECTIONS: STEP 1: Prep natural lashes by lifting lash-line to check for any residues or previous glues. If there are take a clean mascara wand & dip in eye makeup remover. Close just one eye at a time, place the wand on the eye base & let lashes soak for 2 minutes. After 2 minutes thoroughly brush out residue & pat dry. Rinse well w/ baby shampoo. (NOTE: If lashes don't have residue, you can just rinse w/ baby shampoo, pat dry & comb out.) STEP 2: Using the lash tool, hold the lash extensions fully & pull upwards to release. Place the extensions down for easy pickup later. STEP 3: Pick up the inner corner extension first, take the adhesive applicator & apply a thin layer of adhesive onto the base of the extension. Lift your lash-line, place extension from underneath (2 mm away from your natural lash base), gently shimmy it on & release. Fuse section by squeezing the lash base with the tip of lash tool. In a similar fashion, apply the next extension immediately next to previous one without gap, repeat until done with both eyes. AFTERCARE: § Avoid getting extensions wet/steam for 24 hours. § Treat extensions like SILK & avoid tugging, pulling, or putting pressure on them. Sleeping on back is best. § Comb only the middle & tips of your extensions w/ a mascara wand. Fuse lash base daily w/ tool. § Rinse your lashes once a day w/ a baby shampoo + water mixture in a foamy soap bottle. § If section falls off prematurely, you may reapply by cleaning the exposed area w/ eye makeup remover 2 + q-tips, then clean w/ baby shampoo +2 q-tips. Clean extension base same way. Use steps 2 & 3 to reapply.

Price: 8.99 USD

Location: Lakewood, New Jersey

End Time: 2025-01-05T19:57:42.000Z

Shipping Cost: 0 USD