CR-C Multifunction Diesel Common Rail Injector Tester + S60H Nozzle Tester Kit

Description: CR-C Multifunction Diesel Common Rail Injector Tester + S60H Nozzle Tester KitCR-C Multifunction Diesel Common Rail Injector Tester + S60H Nozzle Tester Kit Product Description:CR -c multi-function common rail injector tester using German imported PWM control chip, can accurately and effectively simulate the injector each condition ECU drive signal. Such as pre-injection, emission point, full load point and other conditions.CR -C Common Rail Injector Tester is a simple to operate tool that can be tested using the injector hand pump. It is small in size and light in weight, and can meet the requirements of maintenance personnel in a simple test setup.Product Specification.1.Production Model:CR-C Common Rail Injector Tester 2.Test range:Atomisation, pilot, emission, full load condition. 3.Test injector: for bos-ch, Den-so and Del-phi common rail injector. 4. Power supply: ac110v - 240 v 5. Operating temperature: -30C°-70C°. 6. Driving frequency:1-30Hz. 7.Driving pulse width:100~10000uS 8. Width adjustable: 10ms 9. Over current and short circuit protection. 10.Size:25*19*12CM 11.Product weight:about 1.85kg 12.Boxed. Includes. 1xCR-C main unit 1x main test cable 1x for Bos-ch connector 1x for Delta connector 1x for Den-so connector 1x cable clamp connector 3x fuses 1.Adjustable width: 10 metres 2.Diesel Injector Nozzle Burst Tester Injector Nozzle Tester 0 - 600 BAR / 0 - 8000 PSI Dual Scale Gauge The BOSCH Injector Checker is suitable for use with all common rail injectors and mechanical injectors. The auxiliary product has a compression release valve that allows quick and easy checking of the injection of all types of injectors. It can also be used with the Common Rail Injector 118 Solenoid Tester to test all types of Common Rail injectors. The injector checker is equipped with two different types of tubes. It can be freely switched suitable for testing the injector, which is a good choice for the initial inspection of the working condition of the injector. Injector tester function: 1.Check the diesel injector assembly. 2.Check injector opening pressure. 3. Injector atomisation quality testing. 4.Injector injection angle test. 5.Injector leakage test. Material type: iron Product specification: 46*26*21CM Product weight: 5KG What is the difference between S60 H and S80 H: There are two differences between the plungers, S80H has a large oil volume and S60H has a small oil volume.S60 base is made of plastic and S80 base is made of iron.

Price: 70.99 USD

Location: China

End Time: 2024-08-27T09:00:31.000Z

Shipping Cost: 70.99 USD