CORVETTE, CHEVY, CHEVELLE, CAMARO 64-E-68 OEM-NCRS RESTORED T I AMP #1115005

Description: Up for Sale is an OEM RESTORED Amplifier correct for; 64-E-68, P/N #1115005, Corvette, Chevelle, Camaro, Nova (possibly other GM makes/models) equipped with the K-66 Transistor Ignition. These Amplifiers are original factory OEM units that we have restored. The amp is meticulously restored cosmetically to "original" and are now in Show Condition! The restoration includes: strip paint, re-paint correct shine, with no paint on machined bosses, i.e., factory, backing plate and screws are re-plated dychromate, extension harness is re-wrapped if necessary, and finally a correct Delco decal is applied. Best of all, they are guaranteed/warrantied for 90 Days! Why buy this amp from us? What are your options? The main reason is these are original factory units. Why is that important your ask?: 1) OEM unit has stamped on the single mounting ear boss, the entire P/N 1115005. The reproduction has a full P/N, but cooling fin configuration is quite differen and will lose points. Not even so called NOS (over-the-counter; service replacement) are correct, because they have nothing stamped on the boss area, and have only the last 3 digits (343) stamped on the side. 2) In Judging, please note: the reproduction will typically lose 3-4 points (my opinion, as a Master Judge), due to not only the P/N configuration, but also the cooling fin configuration. The reproduction cooling fin are the same thickness from top to bottom, whereas the OEM is thin at the top and swells to a wider base-easily detectable by the Judges. 3) This unit will have a NEW Delco licensed reproduction module/board, that has up-graded Silicon Transistors (impervious to heat & vibration that kills the OEM germanium transistors), so best of both Worlds: correct configuration with contemporary function/durability. 4) Yes, you could do the restoration work yourself (it is not overly difficult), and even buy the same new module and decal-we sell them separately; we even sell the reproduction complete amp, similar to this listing-see our other listings. The difficult part is getting the backing plate and screws re-plated: you usually need a minimum "load" for a platter to even look at it. 5) You may not have a correct housing, so have to source a correct one, as described above-We have them in stock. Note: This sale is for a "Flat" backing plate which is 100% correct L-67-E-68 and later used on the #1115343 pigtail design. However, if you require a "Cupped" backing plate to fully comply with correct 64-M67; please add $75 extra. Although, this sale is an outright/no core required sale, if you send us your OEM (only) similar core, we will refund $150 when we receive your old core (no broken fins or mounting bosses or cut extension harness or rusty backing plates, please). If you need a Coil, distributor, or TI Service of any type (Distributor custom advance curving available on my Sun distributor Tester)--check out our other listings, or contact us with your needs--we are your One Stop Source for Transistor Ignition K-66 parts and service! We also restore: Vent Window Regulators, C-2 Corvette A & T-Arms, Kelsey Hayes Knock-off/Bolt-on Wheels. Please ask questions, via E-Mail or see last picture: ReNu-A-Vette/Mike Zamora, NCRS Member #12455.

Price: 700 USD

Location: Albuquerque, New Mexico

End Time: 2025-01-12T22:35:49.000Z

Shipping Cost: N/A USD