4pack Sen01114 Furnace Flame Sensor Replacement Part For Trane & American Standa

Description: Material:metal&plastic The flame sensor monitors the burner to detect whether or not a flame is present by sending a DC current through the sensor via the flame itself, received by the computer. If the flame sensor is defective, the furnace may not heat, or start and/or shut off after a few seconds to a minute continuously or intermittently after starting. This part is the most commonly replaced part (after the air filter) Order today Fit Lennox Model :ADD1B080A9451AB ADD1B080A9H31AA ADD1B080A9H31BA ADD1B080A9H31BB ADD1B100A9451AA ADD1B100A9451AB ADD1C100A9481AA ADD1C100A9481AB ADD1C100A9541AA ADD1C100A9541AB ADD1C100A9H51AA ADD1C100A9H51BA ADD1C100A9H51BB ADD1C120A9541AA ADD1C120A9541AB ADD1D120A9601AA ADD1D120A9601AB ADD1D120A9H51AA ADD1D120A9H51BA ADD1D120A9H51BB ADD1D140A9601AA ADD2B060ACV32AA ADD2B060ACV32AB ADD2B080ACV32AA ADD2B080ACV32AB ADD2C100ACV52AA ADD2C100ACV52AB ADD2D120ACV52AA ADD2D120ACV52AB ADE1A060A9361AA ADE1A060A9361AB ADE1B060A9361AA ADE1B060A9361AB ADE1B080A9451AA ADE1B080A9451AB,etc. Not all applicable models are listed,if you have any question please contact us. There are no instructions included in this.If you want too know how to use or install it,Please contact us,we will provide help as much as possible. Replacement Model：4 PC SEN01114 Flame Sensor. The dimension of the SEN01114 flame sensor is 3.4 inch*2.1 inch.The flame sensor can also be replaced by other models, SEN0337, SEN0441, SEN441, SEN491, SEN0491, SEN00491, B340888P01,etc High Quality: Our flame sensors are made of high quality wear resistant metals and ceramics and are rigorously tested by the manufacturer Easy To Install And Cost Saving: Our flame sensors are available in a variety of replacement models and are direct replacements for many Tra-ne furnace models. Following our installation procedures makes installation simple and easy, and you can easily replace a damaged sensor to help you save money Before installing, disconnect the power and close the air valve.Before installing the product, turn off the power and wear work gloves to protect your hands Use Scenario: Detects if your burner flame is lit and sends a signal to the control panel to stop the ignition, length (mounting flange to sensor tip) 2-1/2". Angle sensor offset: 90 degrees. Termination 1/4" male thread quick connect Satisfactory Service: We have many interchangeable flame sensor models, if you are unsure if this model is right for your unit, please feel free to contact us or ask a question via Amazon and we will be happy to help you and offer you a refund or replacement

Price: 18.06 USD

Location: Lathrop, California

End Time: 2024-12-04T12:54:02.000Z

Shipping Cost: 0 USD