2pcs Oxygen O2 Sensor For 2007 2008 2009 10-2012 Toyota Yaris 1.5L Up&Downstream

Description: 2Pcs O2 Oxygen Sensor For 2011-2006 Toyota Yaris 1.5L Sedan Upstream&Downstream Please check fitment notes & description for accurate information. Specification: *Type:Oxygen Sensor *Direct Plug-In Replacement. *Warranty: 1 Year *Built and tested to strict quality control standards *Wires: 4 Wire *Position:Upstream Fit for: Make Model Engine Year Notes TOYOTA YARIS L4-1.5 2014-2012 Sedan ;1Pcs Upstream + 1Pcs Downstream TOYOTA YARIS L4-1.5 2011-2006 1Pcs Upstream + 1Pcs Downstream Pakage Include: 2x Oxygen Sensor Note: For clarification purposes: Upstream location is between the catalytic converter and the engine Downstream location is between the catalytic converter and the tailpipe Install Note: You may be required to reset the vehicle computer after installation of this part. Must Know Before Buying: The following information is for instructional and guidance reference only. We try and make them as accurate as we can. If Check Engine Light is on or an OBDII Trouble/Fault code occurs after installation, check the sensor with a voltmeter as below. If the sensor is good, further diagnosis is required. There're many different codes for specific functional failures, which are NOT necessarily relevant to the sensor. Find out what the Code means before leaving any feedbacks. Items that have been installed, altered or contaminated are non- returnable. ONLY a defective sensor after tested by a voltmeter is applied to manufacturer warranty. 20% restocking fee is required if buyer bought wrong items due to not paying attention to fitment information and ask for return. The Price, Quality & Funcitonality of the O2 Sensor is fully covered under our warranty & return policy. However, refund for any labor cost, expense in a dealer shop or damage due to wrong installation is NOT covered. Q: How do I know the O2 sensor is good or not? (Online Video) A: The only way to know if the O2 sensor is functioning normally is to check its responsiveness to changes in the air/fuel mixture, by Voltage Measurement or Waveform Simulation. Use a 10-megaohm digital voltmeter. Hook up the voltmeter's red probe to the sensor's signal wire and the black probe to engine ground. (Use back probe method, DO NOT pierce the wire.) For a good sensor, voltage should fluctuate constantly between 0.1 and 0.9 volts after starting the engine for 2 or 3 minutes. Please take a video clip of the voltmeter and contact us if our sensor: Goes above range between 0.1 and 0.9 volt Remains below 0.5 volts Stays fixed at a particular voltage You're free to choose replacement or refund if our sensor fails to work, in this case.

Price: 49.81 USD

Location: Chino,CA

End Time: 2024-08-31T03:01:34.000Z

Shipping Cost: 0 USD