2Pcs Oxygen O2 Sensor For 2007-04 Lexus RX330 Toyota 3.3L Upstream & Downstream

Description: 2Pcs Upstream & Downstream O2 Oxygen Sensor For 2007-04 Lexus RX330 Toyota 3.3L Warranty: 3 Year Built and tested to strict quality control standards Note: For clarification purposes: Upstream location is between the catalytic converter and the engine Downstream location is between the catalytic converter and the tailpipe Install Note: You may be required to reset the vehicle computer after installation of this part. Details 2Pcs O2 Oxygen Sensor Left Side Up & Down For 07-04 Lexus RX330 Toyota 3.3L Make Model Engine Year Notes LEXUS RX330 V6-3.3 2006-2004 Left Side;1Pcs Upstream + 1Pcs Downstream TOYOTA HIGHLANDER V6-3.3 2007-2006 Gas Engine ;Left Side;1Pcs Upstream + 1Pcs Downstream TOYOTA HIGHLANDER V6-3.3 2005-2004 Left Side;1Pcs Upstream + 1Pcs Downstream TOYOTA SIENNA V6-3.3 2006-2004 Front;1Pcs Upstream + 1Pcs Downstream Q&A Q: Why does the oxygen sensor have false alarm, after installation ? A: The clearing of the errors can be obtained on most systems when the vehicle battery is disconnected for at least 60 seconds. The assignment of the new sensor parameters is done automatically when the errors are cleared, but in some systems a short adapting tour is required. In this case the vehicle has to be driven on the road for some 10-15 minutes, in order to have the ECU adapt itself to the new sensor. Q: How do I know the O2 sensor is good or not ? A: The only way to know if the O2 sensor is functioning normally is to check its responsiveness to changes in the air/fuel mixture, by Voltage Measurement or Waveform Simulation. Q：How should I install oxygen sensor ? A: The following is the installation instructions: Use the correct part number as listed in the application catalogue ,Do not use sensor if i has been dropped ,Remove protection cap just prior to installation; Firstly install sensor body ensuring lead wire is not twisted or bent , Do not use impact wrench or socket type wrench to install sensor ,M18 sensors - install finger tight then 1/2-3/4 turn with a wrench (35-45Nm) ; Then connect and route lead wire as originally installed , Do not allow lead wire to touch exhaust manifold or any other hot component ,Do not apply any substances (especially oil or grease) to connector sensor ,Do not use leaded fuels,silicone or metal based additives.

Price: 39.78 USD

Location: Perth Amboy, New Jersey

End Time: 2025-01-03T15:20:54.000Z

Shipping Cost: 0 USD