1/64 display case for hot wheels custom diecast car model

Description: Hey! Up for sale i have these high end display cases for your 1/64 car models. These are great for typical 1/64 diecast cars like hot wheels, mini gt, tarmac works, aoshima, tomica, etc. Just double check the dimensions below to make sure your model fits inside. They are also a great addition for your custom models and i have bespoke options listed below. It goes without saying, this is just for the case, no cars are included with your purchase. Outer Dimensions LxWxH 108mm x 52mm x 41mm Inner Dimensions LxWxH 92mm x 42mm x 35mm ->Important Details***This listing is for a single clear case with black base, contact me if your interested in anything other than that ***There are no mounting provisions on these. All car models are different so there is no standard method i could supply. Mounting can be as simple as you want, I prefer to use a rolled up piece of tape under the car. You can also use double stick tape, Velcro, or thumb tac. ***While the materials are super strong, the bolts should not be over tightened to avoid cracking the case. ***Mirror panels have a fine mirror coating on one side of the acrylic. While strong, this coating can be scratched off, so caution is advised. ***Due to the laser cutting process, there may be some hazing on one side of colored panels. Always face the better side outward for the best look. Base panels can only be installed one way and are already set up. ->Materials These are made out of lasercut acrylic. They are a multi piece modular design, and can be assembled easily in minutes. The hardware is stainless steel as well, so it will always look perfect. I use standard phillips head hardware so you wont need to worry about needing any special tools. You could easily swap it out if desired. Once assembled with your car inside, it is very durable and has a quality industrial look and feel. ->Custom Cases There is a lot of freedom with these cases to make them personalized for you. I have a constant rotation of different color acrylics and materials in stock. In addition to different color combinations i can etch any of the panels with anything youd like. Please look at the pictures for some examples. I can also resize the case if you need something bigger. If you are interested in any custom work please message me before ordering to see whats in stock and potential options. Prices will vary. ->Assembly Please look at the assembly pic in the listing, and read below. Message me if you cant figure it out based on these instructions, i plan to make a video eventually. Wearing gloves is recommended to prevent finger prints, and a soft microfiber towel is recommended if you need to wipe the panels clean. Do not use aggressive chemicals on acrylic. -1) Take the 4 side panels and slip them into each other and set them on a table -2) Place the bottom panel with countersink holes facing outward on the “teeth” of the side panels. -3) Slide the square nuts into the side panels and insert and tighten the 2 base screws -4) Flip and repeat steps 2/3 for the top panel -As long as one top or bottom panel is secured you can remove one to access the car inside.

Price: 16 USD

Location: Valley Stream, New York

End Time: 2024-02-24T22:41:42.000Z

Shipping Cost: 4.99 USD