12"X78" ULTRA Black Headlight Taillight Fog Light Tint Film for Lexus

Description: What you will receive:1 Sheet of 12" x 78" ULTRA Headlight Tint Film in BLACK with a lifetime guaranteeThis is enough film to cover both of your headlights. Applying headlight tint film to your car's headlights can enhance the vehicle's aesthetic appeal while providing some protection against scratches and UV light. Here's a step-by-step guide on how to apply headlight tint film:Materials NeededHeadlight tint filmSpray bottle with soapy waterSqueegee or credit cardHeat gun or hair dryerRazor blade or precision knifeMicrofiber clothAlcohol or a cleaning solutionPreparationClean the Headlights: Begin by thoroughly cleaning the headlights with alcohol or a cleaning solution to remove any dirt, grease, or debris. Dry them completely with a microfiber cloth.Measure and Cut the Film: Measure the headlight surface and cut the tint film slightly larger than the headlight size to ensure complete coverage. Leave a margin for adjustment.Prepare the Soapy Water: Fill a spray bottle with soapy water. This solution will help in adjusting the film on the headlight during application.ApplicationWet the Headlight: Spray the soapy water generously on the headlight surface. This step is crucial for allowing the film to be moved and adjusted easily.Apply the Film: Peel off the backing from the tint film and spray the sticky side with soapy water as well. Then, carefully place the film on the headlight. The soapy water will allow you to slide and adjust the film to the perfect position.Squeegee Out the Water: Once the film is in the correct position, use a squeegee or a credit card wrapped in a microfiber cloth to gently push out the soapy water and air bubbles from underneath the film. Start from the center and move towards the edges. Be patient and work slowly to avoid creases or air bubbles.Heat and Stretch: Use a heat gun or hair dryer to gently heat the film, especially around curved areas. This makes the film more pliable and easier to stretch for a perfect fit. Continue to squeegee out any bubbles or wrinkles as you apply heat.Trim the Excess Film: Use a razor blade or precision knife to carefully trim any excess film around the edges. Make sure to cut precisely and avoid scratching the headlight.Final Heating: After the film is applied and trimmed, use the heat gun or hair dryer once more over the entire surface to ensure the film fully adheres to the headlight. This also helps eliminate any remaining small bubbles.Inspect and Clean: Finally, inspect the headlight for any missed spots, bubbles, or imperfections. Clean the tinted headlight with a microfiber cloth for a polished look.TipsWork in a clean, dust-free environment to avoid dust getting trapped under the film.If bubbles appear after application, you can gently pierce them with a needle and squeegee out the air.Practice patience and take your time to ensure a smooth, bubble-free finish.Applying headlight tint film is a meticulous process that can significantly change the look of your car. With the right tools and careful application, you can achieve a professional-looking finish that enhances your vehicle's appearance and headlight protection.

Price: 12.99 USD

Location: Freeport, New York

End Time: 2024-11-13T16:31:12.000Z

Shipping Cost: 0 USD